25 Micro Bangs: A Short, Even Line

Micro bangs sit about an inch above the brow, so there’s nowhere to hide a cowlick, and you’ll be back in the chair for a fringe trim every three to four weeks. They behave best when cut dry, and curly or wavy hair needs extra length left in because the spring pulls the fringe up as it dries.

1. Jaw-Length Bob With Blunt Micro Bangs

On a jaw-length bob, blunt micro bangs create two hard horizontal lines, one at mid-forehead and one at the jaw. With the shears flat, I cut the bob on dry hair, then cut the bangs an inch above the brow in a straight edge with no point cutting. Oval and heart faces with fine to medium density and 1A to 1C texture hold the lines. Use a paddle brush to blow-dry flat and finish with serum. Trim the bangs every three weeks.

2. Long Straight Hair With Mini Bangs

On long straight hair, mini bangs land an inch and a half above the brow and look sharpest when the lengths are smooth. My section is narrow, between the arches; I cut it dry, then soften the corners with a little point cutting. It suits fine to medium density and 1A to 1C texture on oval and oblong faces. Use a flat brush to dry the bangs down and flat iron the lengths. Trim every three weeks.

3. Micro Bangs for Curly Hair

Micro bangs work on curls when every curl is cut dry and two inches longer than the goal, since the spring is that strong. From a narrow section I pick single curls and cut them at the brow, letting them shrink up to mid-forehead. Oval and heart faces with medium to thick density and 3A to 3C texture suit it. Use curl cream and diffuse the fringe forward. Trim every four weeks.

4. Wispy-Cut Micro Bangs

These wispy micro bangs are point cut thin enough for the forehead to show between the strands. Working dry, I cut a shallow section an inch above the brow, then point cut deep until single pieces come apart. It suits fine to medium density and 1A to 2A texture on oval and heart faces. Use a flat brush to blow-dry down, and leave out product so the strands stay apart. Trim every three weeks.

5. Pixie Cut With Mini Bangs

On a pixie, mini bangs set a short fringe at mid-forehead against tapered sides. On dry hair I taper the nape and sides, cut the top to three inches, then cut the bangs an inch above the brow and point cut the ends. Oval and heart faces with fine to medium density and 1A to 2A texture suit it. Dry the bangs down and push the top forward using a light paste. Trim the bangs every three weeks.

6. Oval-Face Micro Bangs

Micro bangs work at any width on an oval face, so I go across the whole width of the brow and keep the line straight. Working dry, I cut an inch above the brow and soften just the corners. It suits fine to thick density and 1A to 2A texture. Use a flat brush to blow-dry down and set it with a light spray. Trim every three weeks.

7. Choppy-Cut Micro Bangs

With choppy micro bangs, I point cut an inch deep so the short line looks broken rather than ruler straight. On dry hair I cut at mid-forehead, then point cut into the ends until the edge breaks into pieces. Oval and square faces with medium to thick density and 1A to 2B texture suit it. Rough-dry it forward and piece the bangs using paste. Trim every three weeks.

8. French Bob With Mini Bangs

A French bob with mini bangs holds the perimeter at the jaw and keeps the fringe short enough to show the forehead. With the shears flat, I cut the bob on dry hair, then cut the bangs an inch above the brow and point cut lightly. It suits fine to medium density and 1A to 2A texture on oval and heart faces. Use a round brush to blow-dry under, then bend the front with a flat iron. Trim every four weeks.

9. Face-Framing Layers With Micro Bangs

Here micro bangs with face framing layers join along a steep angle that drops from mid-forehead to the cheekbone. On dry hair I cut the bangs an inch above the brow, then point cut the face frame starting at the temple so it steps down quickly. Round and square faces with medium density and 1A to 2B texture suit it. Dry the bangs down and the layers back off the face. Trim every five weeks.

10. Fine Hair With Mini Bangs

Micro bangs work on fine hair when I keep the section shallow and leave the ends blunt, which lets the fringe look full even when short. Working dry, I cut an inch above the brow with the shears flat and do no thinning. It suits fine density and 1A to 2A texture on oval and round faces. Use a flat brush and a light spray to blow-dry down. Trim every three weeks.

11. Shag With Micro Bangs

This shag with micro bangs sets razored crown layers with a short fringe sitting above the shortest layer. On dry hair I razor the crown and point cut the ends, then cut the bangs at mid-forehead and run the razor along the edge. Oval and square faces with medium to thick density and 1B to 2B texture suit it. Rough-dry using sea salt spray, then shake it out. Trim every five weeks.

12. Mini Bangs for Over-40 Women

For women over 40, mini bangs work when point cutting softens the edge and the fringe sits an inch and a half above the brow instead of two. I work on dry hair and point cut along the full edge. Oval and heart faces with fine to medium density and 1A to 2A texture suit it. Use a flat brush to blow-dry down, with volumizing mousse at the root. Trim every four weeks.

13. Thick Hair With Micro Bangs

On thick hair, micro bangs must come from a half-inch section, otherwise the short fringe sticks straight out. Working dry, I cut an inch above the brow, then point cut and take out interior weight so the bangs lie down. It suits thick density and 1A to 2B texture on any face shape. Use a flat brush and smoothing cream to blow-dry down. Trim every three weeks.

14. Mini Bangs on Platinum Hair

On platinum, micro bangs get cut after toning, since lightening changes the way the short edge sits. I lift to level ten and tone violet, then cut the bangs an inch above the brow on dry hair with the shears flat. It suits fine to medium density and cool skin tones. Dry the bangs down and use a bond builder once a week. Retouch every four weeks.

15. Sleek Lob With Micro Bangs

This sleek lob with micro bangs puts a short fringe over a collarbone-length perimeter with no layers. With the shears flat, I cut the perimeter on dry hair, then cut the bangs an inch above the brow. Oval and heart faces with fine to medium density and 1A to 1C texture suit it. Use a paddle brush to blow-dry flat, flat iron the lengths and leave the bangs soft. Trim every five weeks.

16. Curved-Edge Mini Bangs

Curved mini bangs are shorter in the center and longer at the temples, so the edge traces the brow line. Working dry, I cut the center an inch above the brow, angle each side down toward the arch and point cut the ends. It suits fine to medium density and 1A to 2A texture on round and square faces. Use a flat brush to blow-dry down. Trim every three weeks.

17. Curtain-Piece Micro Bangs

With micro bangs with curtain pieces, the center stays short while two longer pieces drop at the sides to the cheekbone. On dry hair I cut the center an inch above the brow, then leave a half-inch section on each side long and angle it to the cheekbone. Oval and heart faces with fine to medium density and 1A to 2B texture suit it. Dry the center down and the side pieces out. Trim every four weeks.

18. Micro Bangs on Dark Brunette Hair

Dark brunette with micro bangs makes the short line stand out more clearly against the skin than any other shade. With the shears flat, I cut the bangs an inch above the brow on dry hair, then apply a level four demi root to end. It suits fine to thick density and cool or neutral skin tones. Dry the bangs down and finish using serum. Refresh the tone every eight weeks.

19. Wavy Hair With Mini Bangs

On wavy hair I cut micro bangs at the brow so they pull up to mid-forehead once the bend sets. Working dry, I point cut the ends and check the length again after the waves have dried. Oval and square faces with medium density and 1C to 2B texture suit it. Work a light cream into the bangs and let them air-dry along with the rest. Trim every four weeks.

20. Heart-Face Micro Bangs

Micro bangs suit a heart face when they span the whole forehead, so the wider top balances the narrower chin. On dry hair I cut the full width an inch above the brow and point cut the corners. It suits fine to medium density and 1A to 2A texture. Use a flat brush to blow-dry down and set it with a light spray. Trim every three weeks.

21. Pixie Bob With Mini Bangs

This pixie bob with mini bangs stacks a short nape, drops the front to the earlobe, and sets the fringe at mid-forehead. Working dry, I taper the nape, graduate up to the occipital and angle the front to the earlobe, then cut the bangs an inch above the brow. Oval and heart faces with fine to medium density and 1A to 2A texture suit it. Dry the bangs down and the front under. Trim every four weeks.

22. Micro Bangs on Copper Hair

Copper with micro bangs places the brightest color across the top of the forehead. On dry hair I cut the bangs an inch above the brow, then put a level seven copper on the root and a demi through the ends. It suits fine to medium density and warm skin tones. Dry the bangs down and finish using shine serum. Refresh the tone every five weeks; trim the bangs every three.

23. Blunt Shoulder Cut With Micro Bangs

This blunt shoulder cut with micro bangs sets one hard line at the shoulder and a short one at the forehead. With the shears flat, I cut the perimeter at the shoulder on dry hair, then cut the bangs an inch above the brow. Oval and oblong faces with fine to medium density and 1A to 1C texture suit it. Use a paddle brush to blow-dry flat and turn the ends under. Trim every six weeks.

24. Air-Dry Mini Bangs

Air-dry micro bangs are point cut deep so the short pieces settle where they like with no brush needed. Working dry, I cut an inch above the brow and point cut until the edge splits apart. Any face shape works, with fine to medium density and 1C to 2B texture. Put a light cream on the damp bangs, press them down and leave them alone. Trim every four weeks.

25. Inverted Bob With Micro Bangs

This inverted bob with micro bangs stacks a short back, drops the front to the chin, and puts a short fringe at mid-forehead. On dry hair I graduate the nape and angle the front to the chin, then cut the bangs an inch above the brow. Oval and heart faces with fine to medium density and 1A to 2A texture suit it. Dry the bangs down and the front under. Trim every four weeks.

See also french bangs and short hair with bangs.

Micro bangs read sharpest as a short, even line well above the brow, because that brevity is what makes the cut look deliberate. A small flat iron keeps the edge straight.

Jenna Living
New mom embracing the chaos and creativity! 💕 Sharing budget-friendly tips for cooking, DIY hacks, home decor, fashion, and making every moment stylish and affordable
Scroll to Top