25 Asymmetrical Pixie: One Side Longer

An asymmetrical pixie cut usually needs a trim every four to five weeks, since the clippered side looks fuzzy well before the long side loses its line. The short side is usually clippered or scissor cut to an inch, while the long side runs four to six inches and gets cut dry so the diagonal sits right.

1. Side-Swept Asymmetrical Pixie

In a side swept asymmetrical pixie, the five-inch top crosses the forehead to the cheekbone and the other side is clippered above the ear. On dry hair, I take the short side down with a number two, then point cut the long side so it narrows toward the cheekbone. It works best on oval and square faces with fine to medium density and 1A to 2A texture. Use a flat brush to dry the top across. Trim every five weeks.

2. Jaw-Length Asymmetrical Pixie Bob

In the asymmetrical pixie bob, one side reaches the jaw and the other side and nape stay short and graduated. With the hair dry, I graduate the nape up to the occipital, scissor cut the short side to an inch, and angle the long side to the jaw holding the shears flat. Oval and heart faces with medium to thick density and 1A to 2A texture hold the line. Dry it flat using a paddle brush. Trim every five weeks.

3. Skin Fade Platinum Asymmetrical Pixie

This is the highest-contrast take on the cut: platinum over a skin fade, with scalp showing on one side and white hair on the other. On dry hair, I fade the short side from a zero up to a number two, take the long side to five inches, then lift to a level ten and tone violet. It works for fine to medium density and cool skin tones. Dry the long side over and use a bond builder weekly. Retouch every four weeks.

4. Tapered-Side Curly Asymmetrical Pixie

On an asymmetrical pixie, curls get cut dry one at a time, with five inches of shrunken length on the long side and the short side tapered to the skin. I clipper the taper on dry hair, then shape the long side curl by curl so it falls over one eye. It works on oval and heart faces with medium to thick density and 3A to 3C texture. Put curl cream on wet hair and diffuse on low. Trim every seven weeks.

5. Asymmetrical Pixie Cut for Women Over 50

For clients over 50, I hold the asymmetry to an inch and a half, sweep the long side to the cheekbone, and scissor cut the short side instead of clippering it. Working dry, I point cut the long side at four inches and leave two on the short side. It works on most face shapes with fine to medium density and 1A to 2A texture. Dry using volumizing mousse and a small round brush. Trim every five weeks.

6. Blunt-Fringe Asymmetrical Pixie Bob

On an asymmetrical pixie bob, a blunt fringe sets a horizontal line at the brow against the long side’s diagonal. With the hair dry, I graduate the nape, clipper the short side, angle the long side to the jaw, and cut the fringe at the brow with flat shears. It works on oval and oblong faces with fine to medium density and 1A to 1C texture. Dry the fringe down. Trim the fringe every three weeks.

7. Thick-Hair Razored Asymmetrical Pixie

On thick hair, an asymmetrical pixie needs a razor through the long side so the weight tapers off rather than hanging like a block. With the hair dry, I clipper the nape and short side, then razor the top and long side at five inches and take out interior bulk. It works on any face shape with thick density and 1A to 2B texture. Rough-dry using smoothing cream, then piece with paste. Trim every five weeks.

8. Long-Bang Copper Asymmetrical Pixie

On an asymmetrical pixie, copper looks brightest on the long bangs, which catch light as they cross the forehead. With the hair dry, I clipper the short side, take the top to four inches, angle the bangs to the cheekbone, then put a level seven copper on the root and a demi through the ends. It works for fine to medium density and warm skin tones. Dry the bangs across and finish with serum. Refresh the tone every five weeks.

9. Disconnected-Top Asymmetrical Pixie

With a disconnected top, an asymmetrical pixie keeps a hard line between the six-inch top and the clippered short side. On dry hair, I clipper the nape and short side to a number three, then cut the long side and top at six inches with no blending. It holds the line on oval and heart faces with medium to thick density and 1A to 2A texture. Dry the top over the line and piece it with wax. Trim every four weeks.

10. Fine-Hair Asymmetrical Pixie Bob

On fine hair, a jaw-length asymmetrical pixie needs a blunt long side, since point cutting thins out the perimeter. With the hair dry, I scissor cut the short side to an inch, softly graduate the nape, and cut the long side to the jaw holding the shears flat. It works on round and oval faces with fine density and 1A to 2A texture. Put mousse on damp roots and lift the crown with a round brush. Trim every five weeks.

11. Shaved-Side Wavy Asymmetrical Pixie

On an asymmetrical pixie, the long side needs six inches for waves to bend, so I keep the top long and shave the opposite side to a number one. With the hair dry, I clipper the nape and short side, then point cut the top and long side. It works on oval and heart faces with medium density and 1C to 2B texture. Scrunch sea salt spray into damp hair and rough-dry toward the long side. Shave every two weeks.

12. Shaved Line Design Asymmetrical Pixie

On an asymmetrical pixie, a shaved line through the short side makes the clipper work a feature. With the hair dry, I clipper the short side to a number one, trim one line from temple to crown, and take the long side to five inches. It works on oval and heart faces with medium to thick density and 1A to 2B texture. Dry the long side over and piece with wax. Re-cut the line every two weeks.

13. Dark Brunette Asymmetrical Pixie Bob Cut

On a jaw-length asymmetrical pixie, dark brunette makes the diagonal look like a drawn line. With the hair dry, I graduate the nape, clipper the short side, and angle the long side to the jaw, then apply a level four demi from root through ends. It works for fine to thick density and cool or neutral skin tones. Dry it flat using a paddle brush and finish with serum. Refresh the tone every eight weeks.

14. Round-Face Asymmetrical Pixie

For a round face, the asymmetrical pixie works when the crown has height and the long side falls below the jaw. With the hair dry, I clipper the short side, graduate the nape high, and angle the long side an inch under the jaw. It works for medium to thick density and 1A to 2B texture. Lift the crown with a round brush while drying and keep the long side smooth against the cheek. Trim every five weeks.

15. Micro-Bang Asymmetrical Pixie

On an asymmetrical pixie, micro bangs end an inch above the brow on a slight diagonal. With the hair dry, I clipper the nape and short side, take the top to four inches, and cut the bangs an inch above the brow, point cutting the ends. It works on oval and heart faces with fine to medium density and 1A to 1C texture. Use a flat brush to dry the bangs down. Trim the bangs every three weeks.

16. Honey Blonde Asymmetrical Pixie Bob Cut

On a jaw-length asymmetrical pixie, honey blonde warms the long side without brass, and the close-cut side stays one shade darker. With the hair dry, I graduate the nape, clipper the short side, angle the long side to the jaw, then lift to a level eight and tone gold-beige. It works for fine to medium density and warm skin tones. Dry the long side smooth and finish with a light oil. Tone every six weeks.

17. Undercut-Nape Asymmetrical Pixie

On an asymmetrical pixie, an undercut nape clips the back and short side so the top alone carries length. With the hair dry, I clipper the nape and short side to a number one, then cut the top and long side at five inches and point cut the ends. It works on oval and heart faces with medium to thick density and 1A to 2B texture. Dry the top over and piece it with paste. Buzz every two weeks.

18. Shadow Root Asymmetrical Pixie

On a blonde asymmetrical pixie, a shadow root holds depth at the scalp, which matters since the clippered side shows skin. With the hair dry, I clipper the short side, take the long side to five inches, and apply a level six demi at the root, leaving the lengths at level nine. It works for fine to medium density and 1A to 2B texture. Dry the top over. Refresh the root every ten weeks.

19. Grown-Out Asymmetrical Pixie Bob

In a grown out asymmetrical pixie bob, the short side stays tidy at an inch while the long side grows past the jaw. With the hair dry, I scissor cut the short side, lightly graduate the nape, and point cut only the long side’s ends. It works on any face shape with fine to thick density and 1A to 2B texture. Dry the long side forward and tuck the short side. Tidy the short side every five weeks.

20. Point-Cut Textured Asymmetrical Pixie

On an asymmetrical pixie, point cutting an inch into the long side breaks it into pieces over the clipped side. With the hair dry, I clipper the nape and short side, take the long side to five inches, and point cut the top and ends. It works on oval and square faces with medium to thick density and 1A to 2B texture. Rough-dry using texture spray, then piece with paste. Trim every five weeks.

21. Square-Face Asymmetrical Pixie

An asymmetrical pixie suits a square face when the long side sweeps past the cheekbone to soften the jaw corner. With the hair dry, I clipper the nape and short side, take the long side to five inches, and angle the front below the cheekbone with point cut ends. It works for medium to thick density and 1A to 2B texture. Dry the crown up and the long side across. Trim every five weeks.

22. Gray Asymmetrical Pixie Bob Cut

On a jaw-length asymmetrical pixie, gray hair looks bright on the long side against the darker close-cut side. With the hair dry, I graduate the nape, scissor cut the short side to an inch, and angle the long side to the jaw holding the shears flat. It works on any face shape with fine to medium density and 1A to 2A texture. Dry with a round brush and finish with violet-toned serum. Trim every five weeks.

23. Face-Framing Asymmetrical Pixie

A single long face framing piece at the temple of the long side gives an asymmetrical pixie one line that falls past the cheekbone. With the hair dry, I clipper the nape and short side, take the top to four inches, and leave the temple piece at six with point cut ends. It works on square and round faces with fine to thick density and 1A to 2B texture. Dry the top over and the piece forward. Trim every five weeks.

24. Sleek Flat-Combed Asymmetrical Pixie

When combed flat, an asymmetrical pixie shows its diagonal as one clean edge across the forehead. With the hair dry, I clipper the nape and short side to a zero, then cut the long side at five inches holding the shears flat. It works on oval and square faces with fine to thick density and 1A to 1C texture. Dry it flat using a paddle brush, smooth with a flat iron, and finish with serum. Trim every four weeks.

25. Air-Dry Asymmetrical Pixie Bob

An asymmetrical pixie bob air-dries well once the long side is point cut to fall in pieces. With the hair dry, I clipper the short side, softly graduate the nape, angle the long side to the jaw, and point cut deep into the ends. It works on any face shape with fine to medium density and 1C to 2B texture. Put a light cream on damp hair, push the long side forward, and leave it alone. Trim every six weeks.

For more, see short haircuts for women and wispy bangs.

An asymmetrical pixie builds from the long side swept forward over a closely cut opposite side, because that single difference is what gives the edge. A side part shows the shape.

Jenna Living
New mom embracing the chaos and creativity! 💕 Sharing budget-friendly tips for cooking, DIY hacks, home decor, fashion, and making every moment stylish and affordable
Scroll to Top