Thick Straight Hair: A Blunt Line Holds

Thick straight hair can take forty minutes to blow-dry and still hang like a heavy curtain by afternoon, since there’s no bend to break up the weight. The fix is in the cut: a crisp perimeter plus slide cutting through the interior so the bulk sits flat. Most of these haircuts for thick straight hair use both.

1. Collarbone-Length Blunt Lob

Straight hair shows a clean line better than any other texture, so a blunt collarbone lob is the first of the haircuts for thick straight hair I recommend. I set the perimeter at the collarbone on dry hair, shears held flat, and then slide cut through the interior to debulk it so it sits flat. Thick density with 1A to 1B texture wears it well on long and oval faces. Use a paddle brush to blow-dry, then a little serum. Trim it every eight weeks.

2. Jaw-Length Blunt Bob

Nothing bends the line on thick straight hair, which is why a jaw-length blunt bob looks so sharp on it. Working on dry hair with flat shears, I cut the perimeter at the jaw and then slide cut heavily through the interior to stop the ends flaring. Thick density in 1A to 1B texture works on long and oval faces. Blow it dry flat using a paddle brush and smooth a drop of serum over it. A trim every six weeks keeps the line crisp.

3. Long Layers Over a Debulked Interior

On thick straight hair, long layers won’t move unless the interior gets debulked first. I cut a mid back perimeter on dry hair, point cut layers starting at the collarbone, and then slide cut out the bulk underneath. Thick density with 1A to 1C texture suits most face shapes here. Apply a heat protectant, blow-dry with a large round brush, then run a flat iron over the surface. Trim it every ten weeks.

4. Blunt-Bang Haircuts for Thick Straight Hair

Blunt bangs are among the haircuts for thick straight hair that work best, since straight hair keeps the line with no flat iron needed. On dry hair I cut a collarbone perimeter, take a wide triangle section, then cut the bangs at the brow with flat shears, point cutting only the final quarter inch. Thick density in 1A to 1B texture suits oval and long faces. Use a flat brush to blow-dry the bangs down. Trim the bangs every four weeks.

5. Sleek Long Haircut

Thick straight hair looks its smoothest in a sleek long cut. With the shears flat on dry hair, I cut the perimeter at the mid back, slide cut the interior, and texturize just the final inch. Thick density with 1A to 1B texture works on long and oval faces. Blow it dry flat with a paddle brush, flat iron over a heat protectant, then finish with serum. Trim it every ten weeks.

6. Shoulder-Length Cut With Hidden Internal Layers

Thick straight hair loses its bulk through internal layers, and the surface still reads as one flat sheet. On dry hair I cut the shoulder perimeter with flat shears, then cut layers underneath that never come through to the surface. Thick density in 1A to 1C texture suits most face shapes. Use a smoothing cream and a paddle brush to blow-dry, and the perimeter stays blunt. Trim it every eight weeks.

7. Over-50 Haircuts for Thick Straight Hair

Most of the haircuts for thick straight hair over 50 that I do land at the chin, with long layers and a soft side fringe. On dry hair I cut the perimeter and point cut the ends, point cut layers from the jaw, and cut the fringe running from the part to the cheekbone. Thick density with 1A to 1C texture suits round and oval faces. Blow it dry with a smoothing cream and a round brush. Trim it every six weeks.

8. Curtain-Bang Blunt Lob

On thick straight hair, curtain bangs soften a blunt lob and leave the perimeter untouched. With flat shears on dry hair, I cut the perimeter at the collarbone, take a narrow triangle section, and cut the bangs from the cheekbone down to the jaw. Thick density in 1A to 1C texture works on square and oval faces. Blow the bangs out with a round brush and dry the length flat. Trim the bangs every six weeks.

9. Stacked Graduated Bob

Stacking the back in a graduated bob lets thick straight hair hold a shape rather than just hang. Working on dry hair, I cut the nape short with graduation, build the weight line at the occipital, and keep the front at the jaw. Thick density with 1A to 1C texture suits round and oval faces. Blow it dry rolling under with a round brush and finish with serum. Trim it every five weeks.

10. Long Haircut With Face-Framing Layers

On long thick straight hair, face framing layers open up the face and leave the length alone. On dry hair I cut a mid back perimeter, point cut the front pieces between the jaw and the collarbone, and then slide cut the ends. Thick density in 1A to 1C texture works on square and round faces. Use a round brush to blow the front out and dry the back flat. Trim it every ten weeks.

11. Micro-Bang Blunt Bob

A blunt bob with micro bangs gives thick straight hair two sharp lines. With flat shears on dry hair, I cut the perimeter at the jaw, cut the bangs an inch above the brow the same way, and then slide cut the interior. Thick density with 1A to 1B texture suits long and oval faces. Blow the length dry flat with a paddle brush and the bangs down with a small brush. Trim the bangs every three weeks.

12. Balayage Lob

Nothing hides the placement on thick straight hair, so every balayage stroke shows. On dry hair I cut the collarbone perimeter with point cut ends and slide cut the interior, then hand paint fine ribbons of level nine through the ends and tone it beige. It works on thick density with 1A to 1C texture. Use a paddle brush to blow-dry and finish with serum. Trim every eight weeks and refresh every sixteen.

13. Over-60 Haircuts for Thick Straight Hair

With haircuts for thick straight hair over 60, I hold the perimeter at the collarbone and keep the layers long so everything stays smooth. On dry hair I cut the perimeter with point cut ends, point cut layers starting at the jaw, and slide cut out the bulk. Thick density in 1A to 1C texture suits round and oval faces. Blow it dry with a smoothing cream and a round brush. Trim every eight weeks and gloss every ten.

14. Angled A-Line Bob

An A line bob has a flat back and runs longer at the front, and on thick straight hair the angle shows cleanly. With flat shears on dry hair, I cut the perimeter from the jaw in the back to below the chin in the front, then slide cut the interior. Thick density with 1A to 1B texture works on square and round faces. Use a flat brush to blow it smooth. Trim it every six weeks.

15. Point-Cut Textured Lob

At the perimeter, point cut ends break up the heavy line thick straight hair tends to have. On dry hair I cut the perimeter at the collarbone, point cut deep into the last two inches, then slide cut the interior. Thick density in 1A to 1C texture suits heart shaped and oval faces. Rough-dry it with a texture spray and twist a few pieces with your fingers. Trim it every eight weeks.

16. Side-Fringe Long Pixie

Because nothing bends, a long pixie with a side fringe lies flat on thick straight hair. On dry hair I cut the sides and nape scissor over comb, leave four inches on top, then cut the fringe from the part to the cheekbone and slide cut out the weight. Thick density with 1A to 1B texture suits heart shaped and oval faces. Use a flat brush to blow the fringe across. Trim it every five weeks.

17. Money-Piece Lob

On thick straight hair, a money piece shows as two clean stripes framing the face. With flat shears on dry hair, I cut the perimeter at the collarbone, then lighten both front sections root to end to level nine and tone beige. Thick density in 1A to 1C texture works on round and oval faces. Blow it dry flat using a paddle brush and finish with serum. Refresh the money piece every ten weeks.

18. Side-Part Haircuts for Thick Straight Hair

On thick straight hair, a deep side part shifts the volume to one side so the top doesn’t sit flat. On dry hair I cut a collarbone perimeter with point cut ends, cut long layers starting at the chin, and part deep on the heavier side. Thick density with 1A to 1C texture suits square and round faces. Use a round brush to blow the heavy side across. Trim it every eight weeks.

19. Tucked-Side Blunt Bob

On thick straight hair, tucking one side of a blunt bob shows off the jawline. With flat shears on dry hair, I cut the perimeter below the chin, slide cut the tucked side slightly shorter, and texturize the ends. Thick density in 1A to 1B texture works on square and round faces. Blow it dry flat with a paddle brush, tuck one side behind the ear, and set it with a light hairspray. Trim it every six weeks.

20. Lowlighted Lob

On thick straight blonde hair, lowlights add depth so the flat surface looks dimensional. On dry hair I cut the collarbone perimeter with point cut ends, then weave level six lowlights in fine sections all through the head and gloss the ends. Thick density with 1A to 1C texture suits most face shapes. Use a paddle brush to blow-dry and finish with serum. Trim every eight weeks and refresh every twelve.

21. Long Haircut With Wispy Bangs

For wispy bangs on thick straight hair, I take a narrow section so the fringe doesn’t sit heavy. On dry hair I cut a mid back perimeter with point cut ends, section a narrow triangle, and cut the bangs at the brow with the shears pointed straight in. Thick density in 1A to 1C texture works on oval and long faces. Use a small round brush to blow-dry the bangs. Trim the bangs every four weeks.

22. Curved Inverted Bob

An inverted bob angles from a short back to a long front, and on thick straight hair the curve shows with no styling. On dry hair I cut the nape short with graduation, curve the perimeter down to below the chin at the front, and slide cut the interior. Thick density with 1A to 1C texture suits square and round faces. Blow it dry rolling under with a round brush. Trim it every six weeks.

23. Air-Dry Haircuts for Thick Straight Hair

Straight hair dries flat by itself, so the cuts on thick straight hair that air-dry best are blunt ones with a debulked interior. With flat shears on dry hair, I cut the perimeter at the collarbone and slide cut out the bulk underneath. Thick density in 1A to 1B texture works on most face shapes. Comb a light cream through damp hair, part it to one side, and leave it until it’s dry. Trim it every eight weeks.

24. Copper-Toned Blunt Bob

On thick straight hair, a copper blunt bob looks like one solid block. With flat shears on dry hair, I cut the perimeter at the jaw and slide cut the interior, then apply level seven copper at the root with a demi on the ends. It works on thick density and warm skin tones. Use a paddle brush to blow it flat and finish with serum. Trim every six weeks and refresh the tone every five.

25. Shoulder-Length Cut With Flipped-Out Ends

Instead of thick straight hair just hanging, flipped ends give the perimeter direction. On dry hair I cut a shoulder perimeter with point cut ends, bevel them, and slide cut the interior. Thick density with 1A to 1C texture suits heart shaped and round faces. Use a round brush to blow the ends out, rolling away from the face, and set with a light hairspray. Trim it every eight weeks.

For a similar shape, see shoulder length haircuts for thick hair and haircuts for thick coarse hair.

Haircuts for thick straight hair keep their edge from a blunt perimeter, because layering too much just makes the weight poof at the sides. I cut the line dry at the shoulder and bevel the ends so they sit flat against the neck.

Jenna Living
New mom embracing the chaos and creativity! 💕 Sharing budget-friendly tips for cooking, DIY hacks, home decor, fashion, and making every moment stylish and affordable
Scroll to Top