Angled Bob Haircuts: An Inch Makes the Angle

An angled bob comes down to an inch: the nape sits shorter, the front lands at the jaw or collarbone, and that diagonal has to survive a round-brush blowout on a work morning. I cut these angled bob haircuts dry with the shears flat so the line stays clean, and most need a trim every six to eight weeks.

1. The Classic Jaw-Length Angled Bob

Of all the angled bob haircuts, I show the classic one first: the nape sits an inch shorter than the front, and the front lands at the jaw. Working on dry hair, I cut the nape, then hold the shears flat and angle the line forward to the jaw. Fine to thick density and 1A to 2A texture suit it on round and square faces. Use a round brush to blow-dry, rolling the front under. Trim every six weeks.

2. Collarbone Long Angled Bob Haircuts

With long angled bob haircuts, the front drops to the collarbone and the back stays at the shoulder, so the angle runs over two inches. With hair dry, I cut the back at the shoulder, angle the front down to the collarbone, and point cut the ends. Fine to thick density with 1A to 2A texture suits round, square, and oval faces. Use a round brush to blow-dry smooth and finish with serum. Trim every eight weeks.

3. Curtain-Bang Angled Bob

On an angled bob, curtain bangs soften the diagonal by adding a second line from brow to cheekbone. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, take a triangle section, and cut the bangs from the brow down to the cheekbone. Fine to medium density with 1B to 2B texture suits it on round and square faces. Use a small round brush to blow the bangs out. Trim the bangs every five weeks.

4. Angled Bob Cut for Fine Hair

On fine hair, an angled bob stays blunt along the angle so the line looks thick. With hair dry and the shears flat, I cut the nape an inch shorter than the front, angle to the jaw, and point cut two short crown layers for lift. Fine density and 1A to 2A texture suit it on oval and round faces. Work mousse into damp roots and use a round brush to blow-dry. Trim every six weeks.

5. The Stacked Angled Bob

In a stacked angled bob, graduation at the nape lifts the back while the front falls to the jaw. Working dry, I cut the nape short with graduation, build the weight line at the occipital, and angle the front downward. Fine to thick density and 1A to 2A texture suit it on round and square faces. Use a round brush to blow-dry, rolling the front under and lifting the stack. Trim every five weeks.

6. Layered Long Angled Bob Haircuts

These long angled bob haircuts with layers hold the collarbone angle and add layers from the chin so the front has movement. With hair dry, I cut the back at the shoulder, angle the front to the collarbone, and point cut layers starting at the chin. Fine to medium density with 1A to 2B texture suits most face shapes. Roll the ends under with a round brush as you blow-dry and finish with a light cream. Trim every eight weeks.

7. Angled Bob Cut for Thick Hair

On thick hair, an angled bob needs internal layers so the angle lies flat rather than flaring. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, and point cut internal layers through the sides and back while leaving the outline alone. Thick density with 1A to 2B texture suits any face shape. Use a smoothing cream and a paddle brush to blow-dry flat. Trim every six weeks.

8. Angled Bob for Over 50

My angled bob over 50 puts the front at the chin and the back at the nape, with a side swept fringe reaching the cheekbone. With hair dry, I cut the nape, angle the front to the chin with point cut ends, and cut the fringe from the part down to the cheekbone. Fine to medium density and 1A to 2A texture suit it. Use a smoothing cream and a round brush to blow-dry. Trim every six weeks.

9. The Wavy Angled Bob

In a wavy angled bob, the front pieces are bent so the angle looks softer than it does with a straight blowout. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, and point cut the ends. Fine to medium density with 1B to 2B texture suits it on round and square faces. Use a one-inch iron to wave the front, leave the ends straight, and break it up with texture spray. Trim every six weeks.

10. Side-Part Long Angled Bob Haircuts

Adding a side part to long angled bob haircuts pushes the longer front piece to one side, so the angle is visible from the front. With hair dry, I cut the back at the shoulder, angle the front to the collarbone, and place the part two inches off center. Fine to thick density and 1A to 2B texture suit it on round and square faces. Use a round brush to blow-dry smooth and tuck the short side. Trim every eight weeks.

11. Blunt-Fringe Angled Bob

On an angled bob, a blunt fringe sets a horizontal line against the diagonal. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, and cut the fringe at the brow with the shears flat. Fine to medium density with 1A to 1C texture suits it on oval and oblong faces. Use a flat brush to blow the fringe down and a round brush to turn the bob under. Trim the fringe every four weeks.

12. The Sleek Angled Bob

Because a sleek angled bob shows the diagonal against a flat surface, every piece must lie down. With hair dry and the shears flat, I cut the nape an inch shorter than the front, then angle to the jaw. Fine to thick density and 1A to 1C texture suit it on round and square faces. Blow-dry flat with a paddle brush, flat iron over a heat protectant, and finish with serum. Trim every six weeks.

13. Angled Bob for Over 60

My angled bob over 60 puts the front at the chin, keeps the nape soft instead of stacked, and point cuts the ends so they stay thick. Working on dry hair, I angle the line to the chin, then texturize lightly. Fine to medium density with 1A to 2A texture suits it. Put mousse at the roots and use a round brush to blow-dry. Trim every six weeks and gloss every eight.

14. The Curly Angled Bob

I cut a curly angled bob dry and curl by curl, so the angle still shows after the curl springs up. The nape goes in curl by curl to sit an inch shorter than the front, then I angle the front to the jaw. Medium to thick density and 3A to 3C texture suit it on oval and heart faces. Rake curl cream through wet hair and diffuse on low. Trim every eight weeks.

15. Long Angled Bob Haircuts Cut for Round Faces

For a round face, angled bob haircuts drop the front below the chin so the diagonal draws the eye downward. With hair dry, I cut the back at the shoulder, angle the front to the collarbone, and point cut a single layer below the chin. Fine to thick density with 1A to 2B texture suits it. Use a round brush to blow-dry smooth and lift the crown. Trim every eight weeks.

16. Money-Piece Angled Bob

On an angled bob, a money piece brightens the longer front pieces where the angle reaches its longest point. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, and lift the two front sections to level nine before toning beige. Fine to medium density and 1A to 2B texture suit it. Use a round brush to blow the front out. Refresh every ten weeks.

17. The Textured Angled Bob

For a textured angled bob, I point cut deep into the ends so the diagonal looks soft. With hair dry, I cut the nape an inch shorter than the front, angle to the jaw, and point cut an inch into the ends. Medium to thick density with 1B to 2B texture suits it on oval and square faces. Use texture spray to rough-dry and bend the ends with a flat iron. Trim every six weeks.

18. Side-Swept-Bang Angled Bob

On an angled bob, side swept bangs follow the same direction as the diagonal, running from the part to the cheekbone. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, and cut the bangs from the part down to the cheekbone. Fine to medium density and 1A to 2B texture suit it on round and square faces. Use a flat brush to blow the bangs across. Trim the bangs every five weeks.

19. The Copper Angled Bob

On an angled bob, copper looks bright along the diagonal. With hair dry, I cut the nape an inch shorter than the front, angle to the jaw, then put level seven copper at the root and a demi through the ends. Fine to medium density and warm skin tones suit it. Use a round brush to blow-dry and finish with serum. Trim every six weeks and refresh the tone every five.

20. Balayage Long Angled Bob Haircuts

With balayage on long angled bob haircuts, I paint the front brightest, where the angle is longest. Working dry, I cut the back at the shoulder, angle the front to the collarbone, and hand paint the front pieces and ends to level nine. Fine to thick density with 1A to 2B texture suits it. Use a round brush to blow-dry and finish with serum. Refresh every twelve weeks.

21. Angled Bob Cut for Square Faces

For a square face, angled bob haircuts drop the front below the jaw so the diagonal moves past the corners. With hair dry, I cut the nape an inch shorter than the front, angle the front to an inch below the jaw, and point cut the ends. Fine to thick density and 1A to 2B texture suit it. Use a round brush to blow-dry, rolling the front under. Trim every six weeks.

22. Shadow-Root Angled Bob

On a blonde angled bob, a shadow root holds depth at the part and keeps light along the angle. Working dry, I cut the nape an inch shorter than the front, angle to the jaw, then put a level six demi on the root and leave the lengths at level nine. Fine to medium density with 1A to 2B texture suits it. Use a round brush to blow-dry. Trim every six weeks and refresh the root every ten.

23. Angled Bob Cut for Straight Hair

On straight hair, an angled bob holds its diagonal with no product, so the cut must be clean. With hair dry and the shears flat, I cut the nape an inch shorter than the front, then angle to the jaw. Fine to medium density and 1A to 1C texture suit it on round and square faces. Use a paddle brush to blow-dry flat and a flat iron to bend the front under. Trim every six weeks.

24. The Dark Brunette Angled Bob

On an angled bob, dark brunette makes the diagonal look sharp against the skin. Working dry with the shears flat, I cut the nape an inch shorter than the front, angle to the jaw, and apply a level four demi root to end. Fine to thick density and cool or neutral skin tones suit it. Use a paddle brush to blow-dry flat and finish with serum. Refresh the tone every eight weeks.

25. Air-Dry Long Angled Bob Haircuts

Angled bob haircuts made to air-dry get a single layer below the chin and a side part, so the angle falls into place with no brush. With hair dry, I cut the back at the shoulder, angle the front to the collarbone, and point cut one layer below the chin. Fine to medium density with 1C to 2B texture suits any face shape. Smooth a light cream through damp hair, side part it, and leave it. Trim every eight weeks.

Another angle: pixie haircut for round faces and short hair for oval face shape.

Angled bob haircuts turn on about an inch: the nape shorter, the front to the jaw, and a round brush turning the ends under is what keeps the line. A trim every six weeks holds the angle.

Jenna Living
New mom embracing the chaos and creativity! 💕 Sharing budget-friendly tips for cooking, DIY hacks, home decor, fashion, and making every moment stylish and affordable
Scroll to Top