Hair for Square Face Shape: Soften the Jaw

A blunt perimeter that stops at the jaw is the line I steer square faces away from, since it repeats the angle you want softer. These cuts land at the lip line, collarbone, or shoulder, point cut on dry hair so the ends stay soft. Good hair for a square face shape is mostly about where that line sits.

1. Side-Part Long Layers

When I cut hair for square face shape clients, long layers with a side part come first, since the diagonal line softens the jaw. On dry hair I cut the perimeter two inches below the collarbone, then point cut layers from the chin down. Fine to thick density with 1A to 2B texture works best. Part to one side, dry with a round brush, and finish with serum. Trim every eight weeks.

2. Wavy Collarbone Lob

With a collarbone lob with waves, movement sits right next to the jaw so the angle looks softer. On dry hair I cut the perimeter at the collarbone with point cut ends, then add a single long layer at the chin. It suits a square face with fine to medium density and 1B to 2B texture. Wave with a one-inch iron, leave the last inch straight, and break it up with a light spray. Trim every eight weeks.

3. Long Layers With Curtain Bangs

On a square forehead, curtain bangs break up the width and taper past the cheekbone rather than stopping at the jaw. I section a triangle, cut the bangs from brow to cheekbone, and point cut long layers from the collarbone. Fine to medium density, 1B to 2B texture. Use a small round brush to dry the bangs out. Trim the bangs every five weeks.

4. Soft-Layered Short Hair for Square Face Shape

For short hair for square face shape clients, the perimeter has to sit above the jaw rather than on it. On dry hair I cut a bob at the lip line with point cut ends, then point cut soft layers through the sides. It suits fine to medium density and 1B to 2B texture. Dry with a smoothing cream and a round brush rolling under. Trim every six weeks.

5. The Shoulder Length Shag

Texture around the jaw is what a shoulder length shag adds, so the corners look softer. On dry hair I cut the perimeter at the shoulder, point cut short layers at the crown, and razor the face frame from the cheekbone down. Best on a square face with medium to thick density and 1B to 2C texture. Rough-dry with texture spray and scrunch the ends. Trim every eight weeks.

6. The Side Swept Pixie

I leave length through the top of a side swept pixie so a diagonal fringe can cross the forehead. On dry hair I scissor over comb the sides and nape, keep four inches on top, and cut the fringe from the part to the cheekbone. It suits a square face with fine to medium density and 1A to 2A texture. Dry the fringe across on a flat brush and set with a light paste. Trim every five weeks.

7. Over-50 Hair for Square Face Shape

Of all the hair for square face shape over 50, the cut I do most is shoulder length with a side fringe and long layers. On dry hair I cut the perimeter at the shoulder with point cut ends, point cut layers from the chin, and cut the fringe from the part to the cheekbone. Fine to medium density, 1A to 2A texture. Dry it with a smoothing cream and a round brush. Trim every eight weeks.

8. Long Hair With a Wispy Fringe

Where a blunt fringe would make a square forehead look squarer, a wispy fringe softens it. On dry hair I cut the fringe at the brow, point cut deep so it separates, and keep the length past the collarbone with long layers. It suits fine to medium density and 1A to 2A texture. Dry the fringe down with a small brush and let the rest air-dry. Trim the fringe every four weeks.

9. Face-Framing Chin Length Bob

Falling just past the chin, this bob clears the jaw, and face framing layers break up the line next to it. On dry hair I cut the perimeter an inch below the chin with point cut ends, then point cut face framing pieces from the cheekbone. Best on a square face with fine to medium density and 1A to 2B texture. Dry with a round brush and tuck one side. Trim every six weeks.

10. Curtain Bangs Short Hair for Square Face Shape

With curtain bangs, short hair for square face shape clients keeps the bob above the jaw while the bangs fall to the cheekbone. On dry hair I cut the perimeter at the lip line with point cut ends, section a triangle, and cut the bangs from brow to cheekbone. It suits fine to medium density and 1B to 2B texture. Use a small round brush to dry the bangs out. Trim the bangs every five weeks.

11. Past-the-Shoulder Beach Waves

Past the shoulder, beach waves add width at the cheekbone, which makes the jaw look narrower next to it. On dry hair I cut the perimeter three inches below the collarbone with point cut ends, then point cut long layers. It suits a square face with medium to thick density and 1B to 2C texture. Air-dry with sea salt spray scrunched into damp hair, or wave with a one-inch iron. Trim every ten weeks.

12. Over-60 Hair for Square Face Shape

With hair for square face shape over 60, I keep the perimeter at the chin with a side swept fringe and soft layers. On dry hair I cut the perimeter an inch below the chin with point cut ends, point cut layers from the cheekbone, and cut the fringe to the cheekbone. Fine to medium density, 1A to 2A texture. Dry it on a round brush with a smoothing cream. Trim every six weeks and gloss every eight.

13. Long-Fringe Textured Crop

On a textured crop with a long fringe, the sides stay close and the weight goes forward over the forehead. On dry hair I scissor over comb the sides, point cut the top to three inches, and leave the fringe to the brow before point cutting it. It suits a square face with fine to medium density and 1B to 2B texture. Rough-dry with texture paste and push the fringe to one side. Trim every five weeks.

14. Side-Part Layered Lob

For a square face, a layered lob with a side part is the mid length cut that stays easy. On dry hair I cut the perimeter at the collarbone with point cut ends, point cut layers from the chin, and part on the heavier side. Fine to medium density with 1A to 2B texture. Dry with a round brush, rolling the ends under. Trim every eight weeks.

15. Wavy Short Hair for Square Face Shape

When short hair for square face shape clients has wave, it sits best at the lip line, where the bend falls next to the cheekbone instead of the jaw. On dry hair I cut the perimeter at the lip with point cut ends and keep the interior solid. It suits fine to medium density and 2A to 2C texture. Scrunch sea salt spray into damp hair, part to one side, and air-dry. Trim every six weeks.

16. Face-Framing Layers on Long Hair

Starting face framing layers at the cheekbone pulls the eye away from a square jaw. On dry hair I cut the perimeter past the collarbone with point cut ends, point cut the face frame from cheekbone to collarbone, and keep the back long. Fine to thick density, 1A to 2B texture. Use a round brush to dry the face frame away from the face. Trim every ten weeks.

17. Curly Cut at Shoulder Length

On a square face, a curly shoulder length cut gives width at the cheekbone and softness at the jaw. On dry hair I cut the perimeter at the shoulder curl by curl, then cut layers from the chin so the curl stacks. It suits medium to thick density and 3A to 3C texture. Rake curl cream through wet hair, diffuse on low, and sleep in a satin bonnet. Trim every ten weeks.

18. Long-Top Side Part Pixie

Keeping the lift off center with a long top and a side part makes the forehead look less wide on a pixie. On dry hair I scissor over comb the sides and nape, keep five inches on top, and point cut it. Best on a square face with fine to medium density and 1A to 2A texture. Dry the top to one side on a round brush and set with a light paste. Trim every five weeks.

19. Curtain Bangs on a Shoulder Length Cut

On a shoulder length cut, curtain bangs frame a square face on each side from brow to cheekbone. On dry hair I cut the perimeter at the shoulder with point cut ends, section a triangle, cut the bangs to the cheekbone, and point cut one layer at the chin. Fine to medium density, 1B to 2B texture. Dry the bangs out on a small round brush. Trim the bangs every five weeks.

20. The Razor Cut Lob

Razoring a lob keeps the ends soft so no hard line sits near the jaw. On dry hair I cut the perimeter at the collarbone, razor the last two inches, and razor face framing pieces from the cheekbone. It suits a square face with medium to thick density and 1B to 2B texture. Rough-dry with a light cream and let the ends fall as they want. Trim every eight weeks.

21. Side Swept Fringe Short Hair for Square Face Shape

On short hair for square face shape clients, the detail I add most is a side swept fringe, since the diagonal crosses the forehead. On dry hair I cut a bob at the lip line with point cut ends, then cut the fringe from the part to the cheekbone. Fine to medium density with 1A to 2A texture. Dry the fringe across on a flat brush and the bob under. Trim every six weeks.

22. Balayage on Long Hair

For a square face, balayage on long hair places the brightest pieces at the cheekbone and keeps depth at the jaw. On dry hair I cut the perimeter past the collarbone with point cut ends and long layers, then hand paint to a level nine from the cheekbone down. It suits fine to thick density and 1A to 2B texture. Dry with a round brush and finish with serum. Refresh every twelve weeks.

23. The Wolf Cut

With short layers stacked at the crown and length falling past the shoulder, a wolf cut moves the weight away from the jaw. On dry hair I cut the perimeter below the shoulder, point cut short layers at the crown, and razor the face frame from the cheekbone. Best on a square face with medium to thick density and 1B to 2C texture. Rough-dry with texture spray. Trim every eight weeks.

24. Past-the-Chin Angled Bob

Landing past the chin in front, an angled bob puts a diagonal next to the jaw in place of a horizontal line. On dry hair I cut the nape an inch shorter than the front with point cut ends, keeping the front an inch below the chin. It suits a square face with fine to thick density and 1A to 2A texture. Dry with a round brush rolling under. Trim every six weeks.

25. Side-Part Soft Waves Over 40

On hair past the collarbone, soft waves with a side part give a square face over 40 movement without much morning effort. On dry hair I cut the perimeter past the collarbone with point cut ends and long layers. Fine to medium density, 1A to 2B texture. Wave with a one-and-a-quarter-inch iron, brush it out, and finish with a light spray. Trim every ten weeks.

Worth a look next: hair for oblong face shape and hair for round face shape double chin.

Hair for a square face shape softens when the length falls past the jaw and the layers break the corners, because the jawline is what needs to disappear. A side part moves the eye off the angle.

Jenna Living
New mom embracing the chaos and creativity! 💕 Sharing budget-friendly tips for cooking, DIY hacks, home decor, fashion, and making every moment stylish and affordable
Scroll to Top